Birds MT ELISA Kit

點擊次數：904 發布時間：2017/8/3 18:15:38

· 上傳者：上海極威生物科技有限公司

· 上傳時間：2017/8/3 18:15:38

· 文件大小：31KB

· 文件類型：jpg

· 所屬分類：應用方法

· 下載次數：362次

· 查看次數：904

· 資料簡介： Birds MT ELISA Kit

Catalogue Number: BG37883

(96Tests)

Store all reagents at 2-8°C

Collect sample: serum or blood plasma

Assay range ： 0.8ng/L -280ng/L

FOR LABORATORY RESEARCH USE ONLY.

NOT FOR THERAPEUTIC OR DIAGNOSTIC APPLICATIONS!

PLEASE READ THROUGH ENTIRE PROCEDURE BEFORE

BEGINNING!

INTENDED USE

This MT ELISA kit is intended Laboratory for Research use only ａnd is

not for use in diagnostic or therapeutic procedures.The Stop Solution changes

the color from blue to yellow ａnd the intensity of the color is measured at 450

nm using a spectrophotometer. In order to measure the concentration of MT in

the sample, this MT ELISA Kit includes a set of calibration standards. The

calibration standards are assayed at the same time as the samples ａnd allow the

operator to produce a standard curve of Optical Density versus MT

concentration. The concentration of MT in the samples is then determined by

comparing the O.D. of the samples to the standard curve.

PRINCIPLE OF THE ASSAY

The kit assay MT level in the sample，use Purified antibody to coat microtiter

plate wells, make solid-phase antibody, Samples which including standards of

known concentrations ａnd unknowns are pipetted into coated microtiter wells,

after Incubating ,add Biotinylated anti-IgG,and Combined Streptavidin-HRP,

become antibody – antigen - enzyme- antibody complex, after washing

Completely, Add TMB substrate solution, TMB Chromogen Solution Becomes

blue color At HRP enzyme-catalyzed, And at the effect of acid the color finally

become yellow, The intensity of this coloured product is directly proportional to

the concentration of MT present in the samples. measure the optical densit (OD)

at 450 nm with microtiter plate reader, calculate MT concentration by standard

curve.

REAGENTS PROVIDED

All reagents provided are stored at 2-8° C. Refer to the expiration date on

the label.

1. MICROTITER PLATE 96 wells

2. Biotinylated anti-IgG 6.0 mL 1 tube

3. STANDARD(120ng/L) 0.5ml 1 tube

4. STREPTAVIDIN-HRP 6.0 mL 1 tube

5. STANDARD DILUENT 1.5ml 1 tube

6. Chromogen Solution A 6.0 mL 1 vial

7. Chromogen Solution B 6.0 mL 1 vial

8. STOP SOLUTION 6.0 mL 1 vial

9. WASH SOLUTION x30 20 mL 1 vial

10. Instruction 1

SAMPLE COLLECTION AND STORAGE

Serum- Use a serum separator tube(SST) ａnd allow samples to clot for

30minutes before centrifugation for 15minutes at approximately 1000 x

g.Remove serum ａnd assay immediately or aliquot ａnd store samples at -20 °C

or -80°C.

Plasma - Collect plasma using EDTA or heparin as an

anticoagulant.Centrifuge samples for 15 minutes at 1000 x g at 2-8°C within

30minutes of collection.Store samples at -20°C or -80°C.Avoid repeated

freeze-thaw cycles.

Cell culture fluid ａnd other biological fluids - Remove particulates by

centrifugation ａnd assay immediately or aliquot ａnd store samples at -20°C or

-80°C.Avoid repeated freeze-thaw cycles.

NOTE: Serum, plasma, ａnd cell culture fluid samples to be used within 7

days may be stored at 2-8°C, otherwise samples must stored at -20°C(≤2months)

or -80°C(≤6months) to avoid loss of bioactivity ａnd contamination. Avoid

freeze-thaw cycles .When performing the assay slowly bring samples to room

temperature.

DO NOT USE HEAT-TREATED SPECIMENS.

MATERIALS REQUIRED BUT NOT SUPPLIED

1. Microplate reader capable of measuring absorbance at 450 nm.

2. Precision pipettes to deliver 2 ml to 1 ml volumes. .

3. Adjustable 10ml -100ml pipettes for reagent preparation.

4. 100 ml ａnd 1 liter graduated cylinders.

5. Calibrated adjustable precision pipettes, preferably with disposable plastic

tips. (A manifold multi-channel pipette is desirable for large assays.)

6. Absorbent paper.

7. 37°C incubator.

8. Distilled or deionized water.

9. Data analysis ａnd graphing software..

10. Tubes to prepare standard or sample dilutions.

PRECAUTIONS

1. Do not substitute reagents from one kit lot to another. Standard, conjugate

and microtiter plates are matched for optimal performance. Use only the

reagents supplied by manufacturer.

2. Allow kit reagents ａnd materials to reach room temperature (20-25°C) before

use. Do not use water baths to thaw samples or reagents.

3. Do not use kit components beyond their expiration date.

4. Use only deionized or distilled water to dilute reagents.

5. Do not remove microtiter plate from the storage bag until needed. Unused

strips should be stored at 2-8°C in their pouch with the desiccant provided.

6. Use fresh disposable pipette tips for each transfer to avoid contamination.

7. Do not mix acid ａnd sodium hypochlorite solutions.

8. Serum ａnd plasma should be handled as potentially hazardous ａnd capable of

transmitting disease. Disposable gloves must be worn during the assay

procedure, since no known test method can offer complete assurance that

products derived from human blood will not transmit infectious agents.

Therefore, all blood derivatives should be considered potentially infectious

and good laboratory practices should be followed.

9. All samples should be disposed of in a manner that will inactivate viruses.

10. Solid Waste: Autoclave 60 min. at 121°C.

11. Liquid Waste: Add sodium hypochlorite to a final concentration of 1.0%.

The waste should be allowed to stand for a minimum of 30 minutes to

inactivate the viruses before disposal.

12. Substrate Solution is easily contaminated. If bluish prior to use, do not use.

13. Chromogen Solution B contains 20% acetone, keep this reagent away from

sources of heat or flame.

14. Remove all kit reagents from refrigerator ａnd allow them to reach room

temperature ( 20-25°C).

REAGENT PREPARATION

Standard -The Kit provides a stock standard（120ng/L）. Allow the standard to

sit for a minimum of 5 minutes with gentle mixing prior to making

dilutions.Pipette 150μL of Standard Dilution into each tube.

(total 5 tubes) Use the 150μL of stock solution to produce a 2-fold dilution

series (including 60ng/L,30ng/L,15ng/L,7.5ng/L , 3.75ng/L). Mix each tube

thoroughly before the next transfer.

Wash Buffer - If crystals have formed in the concentrate, warm to room

temperature ａnd mix gently until the crystals have completely dissolved. To

prepare enough Wash Buffer for one plate, add 20mL Wash Buffer Concentrate

into deionized or distilled water to prepare 600mL of Wash Buffer.

ASSAY PROCEDURE

Prepare all Standards before starting assay procedure (see Preparation

Reagents). It is recommended that all Standards ａnd Samples be added in

duplicate to the Microtiter Plate.

1. Determine the number of microwell strips required to test the desired

number of samples, Each sample, standard ａnd blank should be assayed in

duplicate.

2. add sample: Set blank wells separately (blank comparison wells don’t add

sample ａnd ELISA reagent, other each step operation is same). Add 50 μL of

Standards or Samples to the appropriate well of the antibody pre-coated

Microtiter Plate, ａnd Gently mix. Incubate for 45 min at 37℃

3. Configurate liquid: 30 times of wash solution diluted 30 times with distilled

water ａnd reserve.

4. washing: remove Liquid, dry by swing, add washing buffer to every well,

still for 30 second then remove, repeat 4 times.

5. add Biotinylated anti-IgG: Add diluted Biotinylated anti-IgG 50ul to all

wells, Incubate for 30 min at 37℃

6. washing: Operation with 4.

7. add streptavidin-HRP: Add streptavidin-HRP 50ul to all wells, Gently mix

Incubate for 15 min at 37℃

8. washing：Operation with 4.

9. color: Add Chromogen Solution A 50ul ａnd Chromogen Solution B to

each well,Incubate for 15 min at 37℃

10. Stop the reaction: Add Stop Solution50μl to each well, Stop the

reaction(the blue color change to yellow color Immediately).

11. assay: take blank well as zero , measure the optical densit (OD) at 450 nm

after Adding Stop Solution ａnd within 15min.

TYPICAL DATA

CALCULATION OF RESULTS

Average the duplicate readings for each

standard,control, ａnd sample ａnd subtract

the average zero standard optical density.

Construct a standard curve by plotting the

mean absorbance for each standard on the

y-axis against the concentration on the

x-axis ａnd draw a best fit curve through the

points on the graph. This procedure will

produce an adequate but less precise fit of

the data. If samples have been diluted, the

concentration read from the standard curve

must be multiplied by the dilution factor.

阿儀網 設計制作，未經允許翻錄必究. 聯系人：段煜　聯系電話：15214379366 ICP備案號：滬ICP備15046135號-2 總訪問量：4164336 管理登錄

主營產品：ELISA試劑盒，標準品，細胞株，抗體，生物試劑，化學試劑，培養基，血清，實驗耗材，ABcam抗體，CST抗體，Santa抗體，ATCC細胞株，人elisa檢測試劑盒，小鼠elisa試劑盒，大鼠elisa試劑盒，牛elisa試劑盒，羊elisa試劑盒，豬elisa試劑盒，犬elisa試劑盒，植植物elisa試劑盒，elisa 檢測試劑盒報價，試劑盒批發，免費代測elisa 試劑盒，細胞株供應商，實驗外包

掃一掃，關注我們

中文字幕丝袜美腿av_亚洲一区二区无码毛片_任我爽橹在线视频精品一_国产成人无码片av在线

ELISA試劑盒

細胞

標準品對照品

生物試劑

抗體產品

比色法定量檢測試劑盒

人血清

免疫抗原抗體

動物血清

蛋白純化試劑盒

sigma抗體

Birds MT ELISA Kit

相關產品

客戶服務熱線：